• 2B / BW Shalimar Bagh, Opp. BQ Market, Near DLF Mall New Delhi - 110088, India.
  • :+91-9312-871-070
Silver hydrogen peroxide based disinfectant for MP pharma, food and dairy RO systems - Innova Corporate India

Silver Hydrogen Peroxide Disinfectant for MP Pharma, Food & Dairy Plants

Madhya Pradesh has a specific cluster of industries that need disinfection far more demanding than a standard RO plant. The pharma belt around Indore and Dewas, the food processing and dairy units across the Malwa plateau, and the packaged drinking water plants scattered through Bhopal, Jabalpur and Gwalior all face the same problem — they need microbial control that leaves zero toxic residue, passes FDA-grade scrutiny, and does not affect taste, colour or product quality. Chlorine cannot do this. Formalin cannot do this. Silver hydrogen peroxide can.

The formulation is a synergized blend of IP-grade hydrogen peroxide and silver nitrate, stabilized through a precise pH and temperature-controlled process. It works on two fronts: the hydrogen peroxide oxidises bacteria, fungi, viruses and organic matter on contact, while the silver ions provide residual bacteriostatic action that prevents regrowth. It is a cold sterilant — no heating required — which matters for MP's dairy and beverage units where heat-sensitive equipment cannot be steamed. It decomposes into water and oxygen after use, so pipelines, tanks, evaporators and aseptic packaging lines come out clean without a residue that would fail a potability test.

What This Disinfectant Delivers for MP Plants:

  • Cold Sterilant: Works at ambient temperature — no heating needed for dairy and beverage CIP in MP.
  • Broad Spectrum Kill: Effective against bacteria, fungi, viruses and spores — covers pharma and food grade microbial limits.
  • Zero Toxic Residue: Decomposes into water and oxygen — safe for potable water and food-contact surfaces.
  • Chlorine-Free: No chlorinated by-products, no THMs, no membrane damage — a safer alternative to chlorine and formalin.
  • Biofilm Penetration: Breaks down established biofilms on pipelines, tanks and RO membranes.
  • Multi-Application: Suitable for CIP, fogging, spraying and fumigation across MP's food and pharma facilities.
  • Non-Tainting: No odour or colour change in treated water or product-contact surfaces.
  • Residual Protection: Silver ions provide lingering bacteriostatic action that prevents microbial regrowth between cycles.

Application & Dosage for MP Facilities:

Used for microbial control in process water, fruits and vegetables, cooling towers, air-conditioning ducts, CIP lines and packaging equipment across MP. Typical working concentration ranges from 0.002% to 0.5% w/w, depending on the application and the microbial load. Pharma and dairy CIP cycles typically use the mid to upper end of the range; potable water disinfection uses the lower end. For a dose matched to your facility's specific water analysis and hygiene protocol, we recommend a feed water and microbial assessment before finalising.

Safety & Handling:

While handling at your MP facility, wear splash goggles, lab coat, vapour respirator and gloves. In case of skin contact, wash immediately with plenty of water. For eye splashes, flush with fresh water for at least 15 minutes and seek medical attention. Do not inject the product directly into the feed line during normal operation. Full handling procedures and first-aid measures are covered in the Material Safety Data Sheet (MSDS).