- 2B / BW Shalimar Bagh, Opp. BQ Market, Near DLF Mall New Delhi - 110088, India.
- :+91-9312-871-070
Manufacturers, Exporters, Suppliers of RO Antiscalant Low pH
Low pH RO Antiscalant for MP (Acidic Broad Spectrum Formula)
MP's water profile varies sharply from district to district, and so does the scaling problem. Plants in the Malwa plateau belt around Indore, Ujjain and Dewas pull from hard borewells with high calcium and magnesium. Units in the Narmada valley near Jabalpur and Hoshangabad deal with moderate hardness but elevated sulphates. The Bundelkhand region around Gwalior and Sagar adds fluoride and iron to the mix. A single generic antiscalant cannot handle this spread — which is why many MP plants cycle through frequent acid cleanings. Our low pH RO antiscalant is formulated specifically for the acidic, hard-water conditions that dominate MP's industrial feed sources.
The chemistry works at the nucleation stage. When dissolved salts cross saturation — which happens quickly in hard MP borewell water at moderate recovery — they form microscopic crystal nuclei before depositing on the membrane. This formulation interferes at that exact point, distorting crystal growth and keeping the particles suspended in the bulk stream where they exit with the concentrate. The acidic nature of the product makes it naturally suited to high-saline, high-TDS feed streams, where alkaline chemistries struggle with sulphate scales. For MP plants that run continuously and cannot afford unplanned shutdowns, that stability is what keeps recovery from quietly slipping month after month.
What This Antiscalant Delivers for MP Plants:
- Broad Inorganic Coverage: Controls calcium carbonate, calcium sulphate, barium sulphate, strontium sulphate and mixed metal oxides that routinely appear in MP water.
- Flexible pH Window: Delivers stable performance between pH 6.0 and 10.0, so minor fluctuations in feed chemistry don't disrupt scale control.
- Built for Hard & Saline Water: Performs reliably in high-TDS and high-conductivity feed water — a common scenario in the Malwa plateau and Narmada valley belts.
- Economical Dosage: Works effectively at just 1–6 ppm, keeping treatment costs predictable for continuous-operation MP plants.
- Instant Dissolution: Mixes completely and quickly in water, ensuring uniform distribution without settling or stratification in the dosing tank.
- Membrane Compatibility: Safe for polyamide, TFC and CTA membranes — no chemical attack even with round-the-clock dosing.
Technical Specifications:
| Appearance | Clear Liquid |
| pH (as is) | Less than 4.0 |
| Specific Gravity | 1.1 – 1.2 |
| Recommended Dosage | 1 – 6 ppm |
| Solubility | Easily soluble in water |
Dosage & Application: Inject continuously into the RO feed line downstream of pretreatment and upstream of the cartridge filter. For most MP installations, the working dose falls between 2 and 6 ppm, set by feed hardness, TDS, sulphate and recovery. Plants drawing from the Malwa plateau may need the upper end of the range. We recommend a feed water analysis before finalising the dose for your MP plant.
Storage & Safety: Keep the product in its original sealed container, stored in a cool, dry, shaded area at your MP site, away from direct sun and heat. Full safety data and application support are covered in the Technical Data Sheet (TDS) and Material Safety Data Sheet (MSDS).