- 2B / BW Shalimar Bagh, Opp. BQ Market, Near DLF Mall New Delhi - 110088, India.
- :+91-9312-871-070
Manufacturers, Exporters, Suppliers of RO Antiscalant High pH
High pH RO Antiscalant for Rohtak's Alkaline RO Systems
Not every RO system runs at neutral pH. Across the industrial belt of Haryana — from Rohtak and Gurugram to Faridabad, Panipat and Hisar — many plants deliberately operate their RO trains at elevated pH for process reasons or wastewater treatment. Standard antiscalants lose effectiveness in this range. Innova Corporate (India) manufactures a High pH RO Antiscalant built specifically for these alkaline conditions.
The formulation stays stable and effective where conventional chemistry starts to fail. It is designed for plants where high pH is not optional but essential — wastewater recycling units, zero-liquid-discharge (ZLD) systems, and specialty manufacturing operations. Membranes stay clean under these challenging conditions, and system performance stays predictable shift after shift.
Key Features & Strategic Benefits for Local Plants:
- Advanced Scale Inhibition: Controls Calcium Carbonate, Barium, Strontium and Magnesium Sulfates, plus Calcium Fluoride — the scale types that dominate in alkaline RO operation.
- Dual Action Formula: Works as both a powerful scale inhibitor and an alkalinity builder, supporting systems that must maintain elevated pH for process reasons.
- Superior Iron Sequestration: Delivers strong control over iron fouling — a persistent issue in the region's iron-rich borewell water, especially around Rohtak and Panipat.
- Eco-Friendly Chemistry: Fully organic and biodegradable, keeping environmental impact low and discharge compliance easy.
- Cost-Efficient Operation: Low dosage requirement translates into higher recovery and fewer CIP cycles for local plants.
- Wide Compatibility: Safe with all major membrane brands and fully compatible with the INNOVA series coagulants and flocculants.
Dosage & Application Guidelines:
Dose the High pH Antiscalant directly into the RO feed water tank or line, after pretreatment. Typical dosage ranges from 1 ppm to 15 ppm, depending on the parameters below:
- Standard Conditions: 1–5 ppm handles moderate hardness and TDS comfortably.
- High Iron (0.5–1.0 ppm): Increase dosage by 10–15 ppm to stabilise calcium and iron effectively — a common requirement with borewell water in this belt.
- Silica Management: At 10–15 ppm, the formula fully inhibits silica up to 166 ppm.
Storage & Safety: Store in original, tightly sealed containers in a cool, dry place at your site. Keep away from direct heat and sunlight. For precise dosing calculations based on your water analysis, please refer to the Technical Data Sheet (TDS) or contact our specialists in industrial water treatment.