• 2B / BW Shalimar Bagh, Opp. BQ Market, Near DLF Mall New Delhi - 110088, India.
  • :+91-9312-871-070
High pH RO Antiscalant and Alkaline Cleaner for Uttarakhand Industrial RO Plants - Innova Corporate India

High pH RO Antiscalant for Uttarakhand's Alkaline RO Systems

Innova Corporate (India) manufactures a High pH RO Antiscalant designed for membrane systems operating in alkaline conditions. Across the industrial belt of this Himalayan state — from SIDCUL Haridwar and Pantnagar to Rudrapur, Dehradun and Kashipur — many plants run their RO trains at elevated pH for process reasons. This formulation stays effective exactly where conventional antiscalants start to lose performance.

The product is built for facilities where high pH is not optional but essential — wastewater recycling units, zero-liquid-discharge (ZLD) plants, and process-driven RO systems. It keeps membranes clean under these demanding conditions and ensures stable performance even when the feed chemistry is aggressive. For plants dealing with alkaline streams, this is a specialised solution rather than a general-purpose antiscalant.

Key Features & Strategic Benefits for Local Plants:

  • Advanced Scale Inhibition: Controls Calcium Carbonate, Barium, Strontium and Magnesium Sulfates, plus Calcium Fluoride — the scale types most common in alkaline RO operation.
  • Dual Action Formula: Works as both a powerful scale inhibitor and an alkalinity builder, supporting systems that need to maintain elevated pH for process reasons.
  • Superior Iron Sequestration: Delivers strong control over iron fouling — a persistent issue in the region's iron-rich borewell water, especially around Selaqui and Rudrapur.
  • Eco-Friendly Chemistry: Fully organic and biodegradable, keeping environmental impact low and discharge compliance easy.
  • Cost-Efficient Operation: Low dosage requirement translates into higher recovery and fewer CIP cycles for local plants.
  • Wide Compatibility: Safe with all major membrane brands and fully compatible with the INNOVA series coagulants and flocculants.

Dosage & Application Guidelines:

Dose the High pH Antiscalant directly into the RO feed water tank or line, after pretreatment. Typical dosage ranges from 1 ppm to 15 ppm, depending on the parameters below:

  • Standard Conditions: 1–5 ppm handles moderate hardness and TDS comfortably.
  • High Iron (0.5–1.0 ppm): Increase dosage by 10–15 ppm to stabilise calcium and iron effectively — a common requirement with borewell water in the region.
  • Silica Management: At 10–15 ppm, the formula fully inhibits silica up to 166 ppm.

Storage & Safety: Store in original, tightly sealed containers in a cool, dry place at your site. Keep away from direct heat and sunlight. For precise dosing calculations based on your water analysis, please refer to the Technical Data Sheet (TDS) or contact our specialists in industrial water treatment.