Myanmar's 1,900 km coastline along the Bay of Bengal and the Andaman Sea gives coastal industry access to an unlimited water source — but the water itself is one of the toughest feed streams an RO plant can face. Seawater near Mawlamyine, Dawei, and Kyaukphyu typically carries TDS between 32,000 and 38,000 ppm, with hardness, sulfate, and carbonate levels high enough to scale SWRO membranes within weeks if untreated. Innova Corporate (India) supplies this seawater desalination antiscalant for Myanmar coastal plants specifically to handle that chemistry at SWRO operating pressures.
The formula works at the high pressures SWRO membranes run under — typically 55 to 70 bar — where standard brackish-water antiscalants lose effectiveness. It keeps calcium carbonate, calcium sulfate, barium sulfate, strontium sulfate, and magnesium hydroxide in solution through the entire membrane train, and disperses colloidal matter and metal oxides that would otherwise co-deposit with scale and accelerate fouling. The result: stable permeate flow, lower pressure drop, and fewer acid cleanings.
For coastal desalination operators in Myanmar, the biggest cost lever is energy. Scale on SWRO membranes forces higher pump pressure to maintain output, and in a plant running 24/7, that translates directly into kWh per cubic meter. Plants using the correct antiscalant dosage typically see 8–15% lower specific energy consumption compared to those running without adequate scale control — a meaningful number for Myanmar industrial users managing electricity cost.
| Parameter | Value / Description |
|---|---|
| pH (as such) | 9.0 to 10.0 |
| Appearance | Pale Yellow Liquid |
| Water Solubility | Completely Soluble |
| Solid Content | 33% to 34% w/w |
| Specific Gravity | 1.17 to 1.23 |
| Recommended Dosage | 2 – 6 ppm |
| Chemical Composition | Functional phosphino carboxylic acid with advanced silica dispersants |
Recommended Applications in Myanmar: Coastal industrial ports at Mawlamyine and Dawei; resort and hospitality desalination units along the Andaman coast; Kyaukphyu deep-sea port and Special Economic Zone water supply; offshore platform and marine support facility RO systems; municipal seawater desalination pilots for Myanmar's coastal provinces facing freshwater scarcity.
Dosing & Application: Dose continuously into the SWRO feed line after pretreatment and before the high-pressure pump, using a metering pump calibrated to your plant's flow rate. Typical dosage ranges from 2 to 6 ppm depending on feed TDS, recovery rate, and membrane configuration. For Myanmar plants switching between monsoon and dry-season feed conditions, we recommend periodic re-calibration based on updated seawater analysis.
Storage & Handling: Store in original sealed containers in a cool, dry area away from direct sunlight and heat at your Myanmar facility. Keep containers off damp floors during monsoon season to prevent condensation-related contamination. Use appropriate PPE (splash goggles, gloves, apron) during handling. Refer to the Material Safety Data Sheet (MSDS) and Technical Data Sheet (TDS) for complete safety and application details.
Export & Technical Support for Myanmar: We ship regularly to Yangon Port (Thilawa) with onward transport to Mawlamyine, Dawei, Kyaukphyu, and other coastal industrial sites across Myanmar, with complete customs documentation. Our technical team provides free dosage calibration based on your seawater analysis — including Langelier Saturation Index, Stiff & Davis Index, and silica saturation calculations — tailored to your specific site conditions.