- 2B / BW Shalimar Bagh, Opp. BQ Market, Near DLF Mall New Delhi - 110088, India.
- :+91-9312-871-070
Manufacturers, Exporters, Suppliers of RO Membrane Cleaner
RO Membrane Cleaner Chemicals in Oman for Refinery, Power Plant & Mining RO Systems (Acidic & Alkaline CIP Solutions)
Innova Corporate (India) supplies RO Membrane Cleaner Chemicals in Oman for cleaning-in-place (CIP) of refinery boiler feed systems in Sohar, power plant cooling make-up RO across the interior, mining process water in Duqm, and municipal drinking water plants in Salalah. Refinery RO membranes in Sohar face iron oxide and calcium sulfate scaling on the second pass, mining RO systems in Duqm deal with red-brown manganese deposits, and power plant RO units battle carbonate scale that reduces heat transfer efficiency. These foulants cannot be removed by a single cleaning chemical — they need a two-stage CIP programme using an acidic cleaner followed by an alkaline cleaner. Our range covers both, along with iron-specific, silica-specific and preservative formulations.
Our cleaners are formulated for low foaming, precise pH control and easy flushing — critical for refinery and power plant RO systems running continuous operation in Oman. When used as part of a structured CIP schedule, they restore membrane flux and salt rejection, reduce differential pressure and extend membrane life by several years. Omani operators use them across refinery, power, mining, municipal and industrial process water RO trains.
Our Specialized RO Membrane Cleaner Range for Oman:
- Low pH Membrane Cleaner: Dissolves calcium carbonate, calcium sulfate, barium sulfate and iron/manganese oxide scale in Oman refinery and mining RO systems.
- High pH Membrane Cleaner: Removes oil, grease, silica, humic acid and organic matter from power plant and municipal RO membranes across Oman.
- Iron Fouled Membrane Cleaner: Specifically chelates iron and manganese deposits common in Duqm mining and interior borewell water.
- Silica Fouled Membrane Cleaner: Warm alkaline cleaning for silica and silicate scale that standard cleaners cannot remove in Oman.
- RO Membrane Preservative: Protects membranes during shutdowns and storage at Oman refinery and power plant sites.
- RO Dechlorination Chemicals: Removes residual chlorine before it damages polyamide membranes in Oman SWRO and municipal systems.
Industries We Serve Across Oman:
Oil & Gas Refineries (Sohar): Refinery boiler feed and process water RO systems face iron oxide and sulfate scaling. Two-stage CIP using acidic then alkaline cleaning restores performance between production cycles.
Power Generation Plants: Cooling tower make-up and boiler feed RO systems across Oman use membrane cleaners to maintain heat transfer efficiency and reduce blowdown.
Mining Operations (Duqm): Mining process water RO systems face iron, manganese and silica fouling. Iron-specific and silica-specific cleaners restore membrane performance.
Municipal Drinking Water (Salalah, Nizwa): Community RO plants use low-foaming, residue-free cleaners and proper sanitisation between cleaning cycles.
Industrial Process Water: Chemical, cement and heavy manufacturing RO plants across Oman use membrane cleaners for CIP of boiler feed and process water RO trains.
Two-Stage CIP Programme for Oman RO Plants:
| Stage | Cleaner Type | Target Foulant | Typical Dosage |
|---|---|---|---|
| Stage 1 | Low pH (Acidic) Cleaner | Calcium carbonate, sulfate, iron oxide | 1–3% v/v |
| Flush | RO permeate water | Remove residual acid | 15–30 min |
| Stage 2 | High pH (Alkaline) Cleaner | Oil, protein, silica, organics | 2–5% v/v |
| Final Flush | RO permeate water | Return to service | Until neutral pH |
CIP Protocol & Dosage Guide for Oman RO Plants:
- Pre-CIP Inspection: Record differential pressure, permeate flow and salt rejection before starting.
- Solution Preparation: Dilute cleaner with RO permeate water, not raw water, to avoid introducing new contaminants.
- Circulation: Circulate cleaning solution for 30–60 minutes at low pressure (2–4 bar).
- Soak: Soak membranes for 1–2 hours depending on fouling severity. For heavy iron or silica fouling, extend to 4 hours.
- Flush: Flush thoroughly with RO permeate until pH of flush water matches feed pH.
- Post-CIP Check: Measure differential pressure and permeate flow to confirm cleaning effectiveness.
Common Fouling Problems in Oman Refinery, Power & Mining RO Systems:
Iron & Manganese Fouling: Dominant in Duqm mining and Sohar refinery RO systems. Needs chelating iron-specific cleaners to remove red-brown deposits.
Calcium Carbonate Scaling: Standard in high-recovery RO plants across Oman. Removed easily by low pH acidic cleaners.
Calcium Sulfate Scaling: Common in Sohar refinery feed water. Harder to remove; requires low pH cleaning with extended soak.
Silica Scaling: Hard glass-like deposits in interior Oman borewell water. Requires warm alkaline cleaning with extended contact time.
Oil & Grease Fouling: Common in power plant and industrial effluent RO. Requires high pH cleaning with extended soak.
Technical Specifications:
| Appearance | Clear liquid (acidic) / Pale yellow liquid (alkaline) |
| pH (as is) | 2.0 – 4.0 (acidic) / 10.0 – 12.0 (alkaline) |
| Foaming | Low foaming formulation |
| Recommended Dosage | 1–3% v/v (acidic) / 2–5% v/v (alkaline) |
| Solubility | Easily soluble in water |
| Shelf Life | 12 months in original sealed container |
Frequently Asked Questions (Oman):
Q: What types of fouling do RO membrane cleaners remove in Oman?
A: Acidic cleaners remove calcium carbonate, sulfate and iron oxide scale. Alkaline cleaners remove oil, grease, protein, silica and bio-organic fouling. A two-stage CIP programme covers all types.
Q: Which Oman industries need RO membrane cleaning the most?
A: Oil and gas refineries in Sohar, power generation plants across Oman, mining operations in Duqm and municipal water treatment in Salalah use RO membrane cleaning the most.
Q: How often should RO membranes be cleaned in Oman industrial plants?
A: Most refinery and power plant RO systems clean membranes every 2 to 4 months. High-recovery systems or those using iron-rich borewell water may need monthly cleaning.
Q: What is the difference between acidic and alkaline RO membrane cleaners?
A: Acidic cleaners remove calcium carbonate, sulfate and iron oxide scale. Alkaline cleaners remove oil, grease, protein, silica and bio-organic fouling. Both are used in sequence in a complete CIP programme.
Q: Are RO membrane cleaners safe for polyamide and TFC membranes?
A: Yes, when used at recommended pH, temperature and contact time. Always check the membrane manufacturer's cleaning guidelines before use.
Q: Do you supply RO membrane cleaners across Oman industrial cities?
A: Yes, we supply to refinery, power plant, mining and municipal RO facilities across Oman, including Sohar, Duqm, Muscat, Barka, Salalah and Nizwa.
For customized CIP (Clean-In-Place) protocols and to select the right cleaner for your specific water analysis, contact our technical service engineers in Oman. We provide free dosage guidance based on your feed water analysis, membrane type and fouling history.
Related Products: Explore our Complete RO Antiscalant Range for Oman, RO Antifoulant, and RO Dechlorination Chemicals for a complete membrane care programme across Oman.